Araldite ® Hole Filler


EPOXY RESIN PASTE FOR SURFACE REPAIRS
 
USES
To resurface rough and pitted concrete or steel ready to receive an epoxy coating. Ideal for new and old concrete tanks and pipes with blow holes, pitting or depressions. Provides a smooth surface onto which the final coating may be applied

SPECIAL FEATURES
* SOLVENT FREE
* SUITABLE FOR WALLS AND FLOORS
* PREVENTS PINHOLES IN SUBSEQUENT COATINGS

DESCRIPTION
A three-component epoxy Araldite epoxy resin.
The three components are supplied in pre-weighed quantities ready for on site mixing.
Araldite Hole Filler produces a smooth continuous layer ideal for application of an epoxy resin coating and prevents formation of pinholes and other
harmful defects.

PHYSICAL PROPERTIES
 Time at
20° C30° C
Pot life
Initial cure
Over coating time
Full cure		60 min.
12 hours
8-24 hours
7 days		30 min.
6 hours
4-1 2 hours
5 days

CHEMICALS PROPERTIES
Araldite Hole Filler shows good resistance to:
Dilute acids
Dilute alkalis

CAUTION
Keep uncured epoxy materials away from the mouth, food or drink.
Do not use empty tins to store food even if they appear to have been cleaned.
Always wear gloves or barrier cream when handling uncured epoxy materials. Clean any splashes or smears from the skin immediately
using warm water and soap.
Avoid inhaling vapour.
Do not use below 59 C.

NOTICE
The information in this publication, given in good faith, is based on the present state of our knowledge but all recommendations are made without guarantee since the conditions of use are beyond our control. Buyers and users should make their own assessment of our products under their own conditions and for their own requirements.

 

INSTRUCTIONS FOR USE
PREPARATION
The substrate should be clean solid and dry. Fresh concrete should be over 28 days old with a surface moisture below 5 %. Laitence should be removed by acid etching or mechanical means. All debris should then be removed and the concrete left to dry. Surfaces contaminated with oil or grease should be flame cleaned or thoroughly washed with a good detergent followed by clean water and left to dry. Steel surfaces should be sandblasted, primed and then filled with Araldite Hole Filler.

MIXING
Mechanical mixing of resin based materials is preferred whenever possible. Mixers running at less than 400 rpm are recommended.

APPLICATION
Araldite Hole Filler is supplied as three pre-weighed pack in exact proportions. No other materials should be added.
STIR CONTENTS OF EACH TIN THOROUGHLY. Pour the entire contents of the hardener into the resin and mix until uniform. Add the filler slowly while mixing. Continue to mix until a smooth paste is achieved. Apply the paste to the concrete with a steel trowel working it into all cavities and scraping off excess material.
Leave to harden and apply the top coating within the specified overcoating time. If not intercoat adhesion will be impaired.

CLEANING DOWN
Use Huntsman Cleaning Fluid only in well ventilated areas.
Do not use Huntsman Cleaning Fluid on the skin.

CURING
Full cure is achieved within 7 days at 209 C.

COVERAGE
Araldite Hole Filler
6 kg. pack covers 10-15 m2 depending on the roughness of the substrate.

STORAGE
Shelf life of 12 months minimum if stored below 25a C.